Eslope

SCPI Command :

MEASurement<*>:AMPTime:ESLope

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get(measurement=Measurement.Default) → Edge

# MEASurement<*>:AMPTime:ESLope
value: enums.Edge = driver.measurement.ampTime.eslope.get(measurement = repcap.Measurement.Default)

Sets the edge direction to be counted: rising edges, falling edges, or both. The setting is only relevant for edge count measurement (MEASurement<m>:MAIN EDGecount or MEASurement<m>:ADDitional EDGecount,ON) .

Parameters:

measurement – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Measurement’)

Returns:

edges_slope: POSitive | NEGative | EITHer

set(edges_slope: Edge, measurement=Measurement.Default) → None

# MEASurement<*>:AMPTime:ESLope
driver.measurement.ampTime.eslope.set(edges_slope = enums.Edge.EITHer, measurement = repcap.Measurement.Default)

Sets the edge direction to be counted: rising edges, falling edges, or both. The setting is only relevant for edge count measurement (MEASurement<m>:MAIN EDGecount or MEASurement<m>:ADDitional EDGecount,ON) .

Parameters:

• edges_slope – POSitive | NEGative | EITHer

• measurement – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Measurement’)