SkwSlope

SCPI Command :

MEASurement<*>:JITTer:SKWSlope

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get(measurement=Measurement.Default) → Edge

# MEASurement<*>:JITTer:SKWSlope
value: enums.Edge = driver.measurement.jitter.skwSlope.get(measurement = repcap.Measurement.Default)

Sets the edge of the first waveform from which the skew delay or phase is measured: positive, negative or both. The command is available for the following measurement: skew delay and skew phase (method RsRtx.measurement.main.set() and/or method RsRtx.measurement.additional.set() are set to measurements SKWDelay | SKWPhase) .

Parameters:

measurement – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Measurement’)

set(jitter_skw_slp: Edge, measurement=Measurement.Default) → None

# MEASurement<*>:JITTer:SKWSlope
driver.measurement.jitter.skwSlope.set(jitter_skw_slp = enums.Edge.EITHer, measurement = repcap.Measurement.Default)

Sets the edge of the first waveform from which the skew delay or phase is measured: positive, negative or both. The command is available for the following measurement: skew delay and skew phase (method RsRtx.measurement.main.set() and/or method RsRtx.measurement.additional.set() are set to measurements SKWDelay | SKWPhase) .

Parameters:

• jitter_skw_slp – POSitive | NEGative | EITHer

• measurement – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Measurement’)