AmpTime

SCPI Command :

MEASurement<*>:SPECtrum:ARIThmetic:PARameter<*>:AMPTime
Commands in total: 1
Subgroups: 0
Direct child commands: 1
get(measurement=Measurement.Default, measParameter=MeasParameter.Default) → ArithmeticOperation[source]
# MEASurement<*>:SPECtrum:ARIThmetic:PARameter<*>:AMPTime
value: enums.ArithmeticOperation = driver.measurement.spectrum.arithmetic.parameter.ampTime.get(measurement = repcap.Measurement.Default, measParameter = repcap.MeasParameter.Default)

Selects the amplitude/time arithmetics measurements for the measurement group.

Parameters:

  • measurement – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Measurement’)

  • measParameter – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Parameter’)

set(arith_op_1_meas_amplitude_time: ArithmeticOperation, measurement=Measurement.Default, measParameter=MeasParameter.Default) → None[source]
# MEASurement<*>:SPECtrum:ARIThmetic:PARameter<*>:AMPTime
driver.measurement.spectrum.arithmetic.parameter.ampTime.set(arith_op_1_meas_amplitude_time = enums.ArithmeticOperation.AMPLitude, measurement = repcap.Measurement.Default, measParameter = repcap.MeasParameter.Default)

Selects the amplitude/time arithmetics measurements for the measurement group.

Parameters:

  • arith_op_1_meas_amplitude_time – HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta | MEAN | RMS | STDDev | POVershoot | NOVershoot | AREA | RTIMe | FTIMe | PPULse | NPULse | PERiod | FREQuency | PDCYcle | NDCYcle | CYCarea | CYCMean | CYCRms | CYCStddev | PULCnt | DELay | PHASe | BWIDth | PSWitching | NSWitching | PULSetrain | EDGecount | SETup | HOLD | SHT | SHR | CCJitter | NCJitter | CCWidth | CCDutycycle | TIE | UINTerval | DRATe | SKWDelay | SKWPhase | DTOTrigger | PROBemeter | SLERising | SLEFalling | ATAR | SIGNallvl | VOCRossing | NPERiod | CMIN | CMAX

  • measurement – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Measurement’)

  • measParameter – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Parameter’)