Enable

SCPI Command :

BUS<*>:CMSB:NRZ:ENBLe

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get(bus=Bus.Default) → SignalSource

# BUS<*>:CMSB:NRZ:ENBLe
value: enums.SignalSource = driver.bus.cmsb.nrz.enable.get(bus = repcap.Bus.Default)

Selects the input source for the custom serial bus enable signal. If an input is chosen, signals will be only decoded while this channel is in the enabled state. This allows you to mark a time when the signal on the selected source is active and when not. For triggering on a serial bus, analog channels C1–C4 are required. Otherwise, if no serial bus trigger has been selected, permitted source selections include the mathematical channels and the reference channels.

Parameters:

bus – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Bus’)

Returns:

src_nrz_enable: C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 | M7 | M8 | R1 | R2 | R3 | R4| D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15

set(src_nrz_enable: SignalSource, bus=Bus.Default) → None

# BUS<*>:CMSB:NRZ:ENBLe
driver.bus.cmsb.nrz.enable.set(src_nrz_enable = enums.SignalSource.AJ1, bus = repcap.Bus.Default)

Selects the input source for the custom serial bus enable signal. If an input is chosen, signals will be only decoded while this channel is in the enabled state. This allows you to mark a time when the signal on the selected source is active and when not. For triggering on a serial bus, analog channels C1–C4 are required. Otherwise, if no serial bus trigger has been selected, permitted source selections include the mathematical channels and the reference channels.

Parameters:

• src_nrz_enable – C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 | M7 | M8 | R1 | R2 | R3 | R4| D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15

• bus – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Bus’)