Range

SCPI Command :

TRIGger<*>:SLEW:RANGe
Commands in total: 1
Subgroups: 0
Direct child commands: 1
get(trigger=Trigger.Default) → SlewRangeMode[source]
# TRIGger<*>:SLEW:RANGe
value: enums.SlewRangeMode = driver.trigger.slew.range.get(trigger = repcap.Trigger.Default)

Defines the time limit for the slew rate in relation to the upper or lower trigger level (see method RsRtx.trigger.slew.rate.set() and method RsRtx.trigger.slew.delta.set() ) . The time measurement starts when the signal crosses the first trigger level - the upper or lower level depending on the selected slope - and stops when the signal crosses the second level.

Parameters:

trigger – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Trigger’)

Returns:

range_mode: INSRange | OUTRange | LTHan | GTHan

  • INSRange: Triggers on pulses inside a given range. The range is defined by the slew rate ±delta.

  • OUTRange: Triggers on pulses outside a given range. The range is defined by the slew rate ±delta.

  • LTHan: Triggers on pulses shorter than the given slew rate.

  • GTHan: Triggers on pulses longer than the given slew rate.

set(range_mode: SlewRangeMode, trigger=Trigger.Default) → None[source]
# TRIGger<*>:SLEW:RANGe
driver.trigger.slew.range.set(range_mode = enums.SlewRangeMode.GTHan, trigger = repcap.Trigger.Default)

Defines the time limit for the slew rate in relation to the upper or lower trigger level (see method RsRtx.trigger.slew.rate.set() and method RsRtx.trigger.slew.delta.set() ) . The time measurement starts when the signal crosses the first trigger level - the upper or lower level depending on the selected slope - and stops when the signal crosses the second level.

Parameters:

  • range_mode –

    INSRange | OUTRange | LTHan | GTHan

    • INSRange: Triggers on pulses inside a given range. The range is defined by the slew rate ±delta.

    • OUTRange: Triggers on pulses outside a given range. The range is defined by the slew rate ±delta.

    • LTHan: Triggers on pulses shorter than the given slew rate.

    • GTHan: Triggers on pulses longer than the given slew rate.

  • trigger – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Trigger’)