Stime

SCPI Command :

TRIGger<*>:SETHold:STIMe

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get(trigger=Trigger.Default) → float

# TRIGger<*>:SETHold:STIMe
value: float = driver.trigger.setHold.stime.get(trigger = repcap.Trigger.Default)

Sets the minimum time before the clock edge while the data signal must stay steady above or below the data level. The setup time can be negative. In this case, the hold time is always positive. The setup/hold interval starts after the clock edge (setup time) and ends after the clock edge (hold time) . If you change the negative setup time, the hold time is adjusted by the instrument.

Parameters:

trigger – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Trigger’)

Returns:

setup_time: -99.999E-9 to 100E-9

set(setup_time: float, trigger=Trigger.Default) → None

# TRIGger<*>:SETHold:STIMe
driver.trigger.setHold.stime.set(setup_time = 1.0, trigger = repcap.Trigger.Default)

Sets the minimum time before the clock edge while the data signal must stay steady above or below the data level. The setup time can be negative. In this case, the hold time is always positive. The setup/hold interval starts after the clock edge (setup time) and ends after the clock edge (hold time) . If you change the negative setup time, the hold time is adjusted by the instrument.

Parameters:

• setup_time – -99.999E-9 to 100E-9

• trigger – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Trigger’)