Mode

SCPI Command :

PROBe<*>:DEEMbedding:MODE
Commands in total: 1
Subgroups: 0
Direct child commands: 1
get(probe=Probe.Default) → DeembedMode[source]
# PROBe<*>:DEEMbedding:MODE
value: enums.DeembedMode = driver.probe.deembedding.mode.get(probe = repcap.Probe.Default)

Sets the probing mode.

Parameters:

probe – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Probe’)

Returns:

mode: PROBing | TERMinating

  • PROBing: For measurements with a high-ohmic probe and measure on an existing line in parallel to the load.

  • TERMinating: For measurements if the measuring equipment is the load of the line.

set(mode: DeembedMode, probe=Probe.Default) → None[source]
# PROBe<*>:DEEMbedding:MODE
driver.probe.deembedding.mode.set(mode = enums.DeembedMode.PROBing, probe = repcap.Probe.Default)

Sets the probing mode.

Parameters:

  • mode –

    PROBing | TERMinating

    • PROBing: For measurements with a high-ohmic probe and measure on an existing line in parallel to the load.

    • TERMinating: For measurements if the measuring equipment is the load of the line.

  • probe – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Probe’)